Complete electronic ignition kit containing alternator mounted ignition pickup, fittings and amplifier unit. Works with 12 volt 3 Ohm coils ELA14500 (big twins) and can be used to replace Digiplex on models with Ducati charging systems where the bike is converted to carburettors. This kit is just an ignition system, it will not control fuelling. The pickups for this kit are mounted on the alternator stator. Supplied with instructions in German with wiring diagrams.

2 year warranty on Sachse ignition kits

Once fitted no further adjustment should be necessary. Preloaded with nine ignition curves, two of which are designed for twin plugged bikes. See this link for fitting instructions. Some bikes may need at least one additional spacer to allow enough clearance for alternator cover to fit once pickup is fitted. Note that if you are replacing a Digiplex system you will also need to replace your 'square' coils with higher impedance 12 volt coils e.g. ELA14500

 This part is available by special order, request a quote

Black Plastic Number Plate Bracket

 This part is available by special order, request a quote

 31438765 GU31438765 31 43 87 65
 3143 8765 3143.8765 31.43.87.65

Small round left hand bar end mirror finished in black. Knuckle allows adjustment of mirror. Fits all models with open ended (i.e. not threaded) 7/8 inch steel handlebars.

Perfect for achieving that minimal look on your bike

 Availability varies on this part, check availability

Black left hand knee protector, mounts to head and includes rubber pad and washers

See FRA18941 for replacement rubbers for this knee guard

 Sorry, this part is no longer available.

Complete luggage rack with grab rail. Supplied with fitting hardware and instructions

Can be used in conjunction with Hepco pannier rails, Hepco top cases will fit directly onto this carrier

 This part is available by special order, request a quote

Pair of fully adjustable Hagon Nitro rear shock absorbers with ten position adjustable damping, and fully progressive preload adjustment. Black anodised body and springs with automatic compression and rebound balance.
Includes C spanner for preload adjustment.

These are an excellent suspension upgrade over the standard factory fitted shock absorbers - fully adjustable damping and preload allows you to get your bike handling as it should.

Combine with our fork upgrade kit SUA35010 to transform the handling of your V7.

Also fits series 2 Nevada 750, we advise measuring your existing shocks if in doubt about fitment.

All Hagon shocks have a 2 year unlimited kilometer guarantee and are TUV approved. NB these shock absorbers are fitted upside down (Hagon text to top). Also available by special order with chromed springs and/or polished alloy body, please enquire for details

 This part is available by special order, request a quote

Pair of Nitro Race Piggyback Stainless Steel Shocks. Featuring a stainless steel 38mm damper unit with 90mm piggyback reservoir, fully re-buildable, 18mm piston rod, 10 position damping adjustment with automatic compression / rebound balance. 73mm outside diameter natural stainless steel spring, silver anodised aluminium fittings. Fully progressive spring pre-load adjustment. Supplied as a complete pair with mounting bushes, spring adjusting C spanner and 2.5mm hexagon key. These units are designed to be fitted with the damping adjuster at the bottom but will operate in either orientation.

The suspension on the V7 II models is notoriously cheap and is upgraded by most owners, but all V7 models will benefit from this suspension upgrade which will transform handling. Fully adjustable damping and preload allows you to set up your bike handling as it should.

Combine with our fork upgrade kit to transform the handling of your V7.

All Hagon shocks have a 2 year unlimited kilometer guarantee and are TUV approved. Also available by special order with chromed springs and/or polished alloy body, please enquire for details. All Hagon shocks have a 2 year unlimited kilometer guarantee and are TUV approved.

 This part is available by special order, request a quote

K&N high performance air filter, flat paper cartridge type for single throttle body models

• High Air Flow with Excellent Filtration
• Designed to Increase Horsepower and Acceleration
• Washable and Reusable
• Will NOT Void Vehicle Warranty
• Lasts up to 50,000 miles before cleaning is required depending on driving conditions
• K&N Million Mile Limited Warranty�
• Emissions Legal
• Economical, a K&N Air Filter Will Last the Life of Your Bike
• Works with Original Equipment Manufacturer Vehicle Electronics
• Easy High Performance Add-on
• Environmentally Friendly

 This part is due back in stock soon, call 01484 841395 to reserve yours

AP8104924

Black 55 litre Junior top box / top case to match Hepco and Becker Junior panniers. This is the classic Hepco and Becker top box design. Sized to take two helmets

• Unbreakable, special double walled shell made of impact resistant plastic which absorbs bumps and falls
• Completely waterproof thanks to special seals
• Fitted with rugged metal locks and an ergonomic carry handle
• Aerodynamic design
• Racks and accessories available separately

This is a great value top case which are quickly and securely fitted to any Moto Guzzi. The discreet and classic styling looks right on any Guzzi from the 1970's to the present day. Supplied with two keys. See LUA70127 for a Guzzi badge to fit these panniers. This latches to any Hepco or Guzzi rack with a oblong section at the rear, e.g. LUA61051

 This part is available by special order, request a quote

German made chrome lightbar and heavy duty stainless steel spotlights. Single beam spotlights supplied with brackets, bulbs, sheathing, fuses and lead wires. A large central bracket mounts to a existing holes in your lower yoke and positions the lightbar far enough forward to fit this lightbar in conjunction with a screen

 This part is available by special order, request a quote